Electrolux EWX14550W, User Manual

Page: 21 / 32

7. Put the cap back on the emergency emp-
tying hose and place the latter back in its
seat.
8. Screw the pump fully in.
Warning!
When the appliance is in use and depending
on the programme selected there can be hot
water in the pump. Never remove the pump
cover during a wash cycle, always wait until
the appliance has finished the cycle, and is
empty. When replacing the cover, ensure it
is securely re-tightened so as to stop leaks
and young children being able to remove it.
Cleaning the water inlet filter
If you notice that the machine is taking longer
to fill, check that the filter in the water inlet
hose is not blocked.
1. Turn off the water tap.
2. Unscrew the hose from the tap.
3. Clean the filter in the hose with a stiff
brush.
4. Screw the hose back onto the tap.
Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, proceed
as follows:
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Place the end of the emergency emptying
hose and that of the inlet hose in a bowl
placed on the floor and let water drain
out.
4. Screw the water inlet hose back on and
reposition the emergency emptying hose
after having put the cap on again.
5. When you intend to start the machine up
again, make sure that the room temper-
ature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has
cooled down;
4. place a bowl on the floor and place the
end of the emergency emptying hose into
the bowl. Remove its cap. The water
should drain by gravity into the bowl.
When the bowl is full, put the cap back
on the hose. Empty the bowl. Repeat the
procedure until water stops flowing out;
5. clean the pump if necessary as previously
described;
6. replace the emergency emptying hose in
its seat after having plugged it;
7. screw the pump again.
electrolux 21