16 www.electrolux.com
Save Favourite ( ) Program
3.5 Settings
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish to
disable this buzzer when you start a wash
when going to bed, so that when the wash
finished approximately 1 hour later, it will
not disturb you through the night.
Enabling/Disabling End-Of-Wash
Buzzer
Program settings that are frequently used
can be saved (e.g. Cotton, 60°C, 1200
rpm, with Prewash and Vapour).
To program/re-program Favourite with
your own selections and save them,
proceed as follows:
1. Put machine in Stand-By mode.
2. Select your desired wash settings.
To recall the favourite wash program,
turn selector knob to “Favourite ”
program. You will get acknowledgement
on the display when the Favourite
program is loaded.
3. To save favourite program, press and
hold “Prewash” touchpad about
2 seconds and you will hear “Bip, Bip”
sound and “ ” is flashing on the
display.
●
●
●
●
●
●
The drying time can vary according to :
the final spin speed;
dryness level (Extra Dry or Cupboard
Dry or Iron Dry);
the type of laundry;
the size of load.
Duration of the drying cycle
Additional drying
To prevent the formation of creases
or shrinking of fabrics, avoid
excessive drying.
WARNING!
Should the laundry still be too wet at the
end of the program, set another short
drying cycle.
The final part of a washer- dryer cycle
occurs without heat (cool down cycle).
This ensures the laundry will be left at
a low temperature.
After drying fluffy fabrics, such as new
towels, it is advisable to perform a
“Tub Clean” program to ensure that any
residue that may remain in the tub is
completely removed and does not stick to
garments dried afterwards. After each
drying cycle, clean the drain pump filter.
Please refer to care and cleaning in
section 11 “CARE AND CLEANING”.
Fibre residue
Child Safety Lock ( ) Option
Your appliance is provided with CHILD
SAFETY LOCK which permits you to leave
the appliance unsupervised with the door
closed without having to worry that children
might be injured by or cause damage to
the appliance.
Set this option after pressing the
Start/Pause touchpad.
To activate the function, press and
hold “Extra Rinse” touchpad about
2 seconds until the display shows the
icon “ ”.
To set “Child Lock” option:
To deactivate the function, press and
hold “Extra Rinse” touchpad about
2 seconds until the display shows the
icon “ ”.
This function remains enabled
even after the appliance is
switched off.
The touchpads are locked
(except for the On/Off button).
●
●
If you press any touchpad while
Child Lock is activated, the icon
“ ” will flash on display
3 times along with buzzer sound.
