Electrolux EWW7524ADWA, User Manual

Page: 14 / 48

14 www.electrolux.com
The door stays locked with the water
in the drum. To continue the cycle,
you must press (Start/Pause).
●
●
No spin option eliminates all the spin
phases and increase the number of rinses.
No Spin ( )
By selecting this option the water of the
last rinse is not emptied out and the drum
turns regularly to prevent the laundry
creases. The door is still locked to indicate
that the water must be emptied out.
Rinse Hold ( )
Prewash Touchpad
Select this option if you wish your laundry to
be pre-washed before the main wash. Use
this option for heavy soil. The indicator of
this option will be on.
Select this option to add approximately 30
minutes of tumbling in vapour during the
wash cycle. Vapour helps open fabric fibers
up to allow laundry additives to release tough
stains. The indicator of this option will be on.
Vapour ( ) Touchpad
Vapour may not necessarily be visible
inside the drum during a vapour wash
cycle. Vapour is created below the drum
and allowed to naturally rise into the
clothes.
At the end of the Vapour cycle, the clothes
will be warmer, softer and detached from
the drum.
If Vapour option is selected, rinse tempera-
tures will be elevated.
During a vapour cycle, you may notice
vapour exiting from the drain hose of the
Wahser-Dryer, this is normal and there is no
cause for alarm.
Vapour may not be present during the
entire vapour wash cycle.
Vapour function is more effective with half
load.
NOTE
When you set this function, put the detergent
into the “ ” compartment. This function
increases the program duration.
●
●
●
●
Time Dry ( ) Touchpad
If you wish to carry out a timed drying
program, keep pressing this touchpad until
the desired time is reached.
Maximum allowable timed drying
changes based on wash program
selected.
The final time value is the total duration
of the w deta drying
cycles.
●
●
NOTE
Delay Start Touchpad
This option makes it possible to delay the
start of the program by 30 min, 60 min or
90 min and then by every hour from 2 to
20 hours. The delay you have selected is
indicated on the display. The end time will
increase in order to show you the selected
delay.
You must select this option after you have
set the program and before you press the
Start/Pause button. If you wish to add
laundry in the machine during the delay
time, press Start/Pause touchpad to put
the machine in pause mode. Add laundry,
close the door and press Start/Pause
touchpad again.
You can cancel the delay time at any
moment, by pressing “Delay Start”
touchpad repeatedly till the display shows
delay time “ ”, then press the
Start/Pause touchpad.
At the end of the program the
appliance performs the anti-crease
phase for approximately 10 minutes.
During this time, the display will show
time remaining “ ” and door is
locked “ ”.
●
If you wish to open the door
during the anti-crease phase
or interrupt it, press Start/Pause
touchpad.