ENGLISH 11
3.12 Vapour Touchpad
3.11 Prewash Touchpad
3.14 Rinse Plus Option
This option is recommended for
people who are allergic to
detergents, and in areas where the
water is very soft.
To activate this option, press ‘Dry
Time’ and ‘Prewash’ touchpads at
the same time until the display
shows the symbol ‘ ’.
To deactivate this option, press
‘Dry Time’ and ‘Prewash’
touchpads at the same time
until the symbol ‘ ’ goes off.
* Vapour option cannot be
selected, if drying option
has been combined with
the program.
3.13 Start/Pause Touchpad
To start the selected program, press
the ‘Start/Pause’.
To interrupt a program which is
running, press the ‘Start/Pause’ to
pause the machine.
To restart the program from the point
at which it was interrupted, press the
‘Start/Pause’ again.
If you have chosen a delayed start,
after pressing ‘Start/Pause’ the
machine will begin the countdown.
Select this option if you wish your
laundry to be pre-washed before
the main wash. Use this option for
heavy soil. The indicator of this
option comes on.
When you set this function, put the
detergent into the “ ”
compartment. (Refer page 18-19)
This function increases the
program duration.
Select this option
*
to add
approximately 45 minutes of
tumbling in vapour during the wash
cycle. Vapour helps open fabric
fibers up to allow laundry additives
to release tough stains.
The indicator of this option comes on.
Vapour may not necessarily be
visible inside the drum during a
vapour wash cycle. Vapour is
created below the drum and
allowed to naturally rise into the
clothes.
NOTE:
At the end of the Vapour cycle the
clothes will be warmer, softer and
detached from the drum.
If Vapour option is selected,
rinse temperatures will be
elevated.
During a vapour cycle you may
notice vapour exiting from the
drain hose of the washer-dryer,
this is normal and there is no
cause for alarm.
Vapour may not be present during
the entire vapour wash cycle.
Vapour function is more effective
with half load.
- At the end of the program the
appliance performs the
anti-crease phase for approx.
10 minutes. During this time
the display will show time
remaining “ ” and door is
locked ( ).
