Electrolux EWW12746, User Manual

Page: 19 / 120

19 ENGLISH
If you want your laundry to be spun or
use temperature different from the one
proposed by the washer-dryer, pess the
Spin “ ” and the temperature “ ”
touchpads repeatedly to change the spin
speed and temperature. Press the
option touchpads, if you want your
laundry to be washed with special
functions.
Different functions can be combined
which is dependent on the program
selected.
If you want to adjust washing time, press
the “Time Manager ” touchpad
repeatedly to increase or decrease
washing time. See Time Manager guide
on page 14.
If you want to delay the start of the
washing program, press the “Delay
Start ” touchpad repeatedly to
choose your washer-dryer delay time.
5.3 Options Setting
To pause, press “Start/ Pause ”.
The indicator will start flashing.
-
Press the “Start/Pause ” again.
The program will continue.
-
-
-
5.5 Interruption Of A Program
It may be possible to change some of the
options after a wash program has started.
5.7 Changing The Options
Press the touchpad “Start/Pause ”.
The indicator will start flashing.
1.
If available, change the options that
you wish.
2.
Press “Start/Pause ” again.
The program will continue.
3.
1.
2.
While a program or the Delay Start is
operating, the appliance door is locked
and the display shows the indicator “ ”.
First, set the machine to PAUSE by
pressing the “Start/Pause ” touchpad.
Wait until the door lock indicator “ ”
goes off, then the door can be opened.
If the door lock indicator “ ” does not
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency, please
refer to “Emergency door
opening” on page 33.
5.8
Opening The Door
NOTE
If an option is not compatible with the
wash program selected, symbol “ ”
will flash on display along with buzzer
sound.
If you turn the program selector knob to
another program when the machine is
working (except “Off” to switch off the
machine), symbol “ ” will flash on
display along with buzzer sound to
indicate a wrong selection. The machine
will not perform the new selected
program.
The appliance will automatically adjust
the selected program duration according
to the type and size of the load.
-
The display will show adjusted program
duration.
-
To start a program, press the Start/Pause
touchpad. The corresponding pilot light will
stop flashing and a default program duration
will be displayed on the screen.
5.4 Starting A Cycle ( )
After approx. 15 minutes from the
start of a program:
If you press any touchpad while a
program is operating, symbol “ ” will
flash on display along with buzzer sound.
(except “Start/Pause ” touchpad)
-
-
Changing a running program is possible
only by resetting it.
Turn the program selector knob to the
position “Off” to cancel the program
and to turn off the appliance.
-
5.6 Changing A Program
Turn the program selector knob to the
new program position and change any
available options. Press “Start/Pause
” to start the new program.
The appliance will not drain the
water.
-