Electrolux EWW12746, User Manual

Page: 38 / 120

38 www.electrolux.com
This machine is designed to operate on a
220-240 V, single-phase, 50 Hz supply.
13.5
Electrical Connection
“An incorrect power supply may void
your warranty.”
Check that your domestic electrical
installation can take the maximum load
required (2.1 kW), also taking into
account any other appliances in use.
The manufacturer declines any
responsibility for damage or
injury through failure to comply
with the above safety precaution.
Should the appliance power
supply cable need to be
replaced, this shall be carried
out by our Service Centre.
Connect the machine to an
earthed socket outlet.
CAUTION!
Push the drain hose onto the spigot
and secure with a clip, ensure a
loop is formed in the drain hose to
prevent waste from the sink
entering the appliance.
If the outlet spigot has not been
used before, remove any blanking
plug that may be in place.
In a sink, drain pipe branch.
Directly into a drain pipe,
at a height
of not less than 60 cm and not more
than 90 cm.
Max. 90 cm
Min. 60 cm
The end of the drain hose must always
be ventilated, i.e. the inside diameter of
the drain pipe must be larger than the
outside diameter of the drain hose.
The drain hose must not be twisted or
curled. Run it along the floor; only the
part near the drainage point must be
raised.
In this case, make sure the end
cannot come unhooked when the
machine will be emptied. This could
be done by tying it to the tap with a
piece of string or attaching it to the
wall.
For the correct functioning of the
machine, the drain hose must remain
hooked on the proper support piece
situated on the top part of back side of
the appliance.
This branch must be above the trap
so that the bend is at least 60 cm
above the ground.
Max.
90 cm
Min.
60 cm