Cold
water
tap
Cold
10
www.electrolux.com
3.
InstALLAtIon InstRUCtIons (CONT’D)
3.5
Electrical connection
• Do not use an extension cord or double
adaper.
• If the supply cold is damaged, it must be
replaced by a qualified person in order
to avoid a hazard.
• If the machine will not be used for an
extended time, unplug it and shut off the
water supply.
• Connect the machine to a grounded
outlet in occordance with current wiring
regulations.
• The appliance must be positioned so
that the plug is easily accesible.
3.6
Connecting water supply hose
• Water supply pressure must be between
4.5 and 145 PSI (30~1000 kPa).
• Do not crossthread when connecting
inlet hose to the valve. If the water
supply pressure is more than 145 PSI,
a pressure reducing device should be
installed.
• Two Sealing washers are supplied with
the water inlet hoses to prevent water
leaks.
• Check for leakage of washing machine
connections by turning the tap
completely on.
• Periodically check the condition of the
hose and replace the hose if necessary.
• Make sure that there is no kink in the
hose and that it is not crushed.
• Be sure that the two water input ports
are connected to the correct water
faucets. The connector for ho water is
colored red. (Fig.7)
NOTE
Washing Machine is to be connected to the
water mains using new hoses. Old hoses
should not be used.
Repairs to the washing machine must
only be carried out by qualified personnel.
Repairs carried out by inexperienced
persons may cause injury or serious
malfunctioning. Contact your local service
center.
Do not install your washing machine
in a room where temperatures below
freezing may occur. Frozen hoses may
burst under pressure. The reliability of the
electronic control unit may be impaired at
temperatures below the freezing point
If the appliance is delivered in the winter
months and temperatures are below
freezing, store the washing machine at room
temperature for a few hours before putting it
into operation.
3.7
Positioning the washer
•
Installation clearances:
The location
must be large enough to fully open the
washer door.
•
Washer dimensions:
Most installations
require a minimum 4 in. (10 cm)
clearance behind the washer. (Fig.8)
Fig. 7
Summary of Contents for EWW1122DW
