2. Start the programme to drain the wa-
ter.
FROST PRECAUTIONS
If the appliance is installed in an area where
the temperature can be less than 0 °C, re-
move the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5. Empty the drain pump. Refer to the
emergency drain procedure
6. When the drain pump is empty, install
the inlet hose again.
Warning!
Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
TROUBLESHOOTING
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some problems, the display
shows an alarm code:
•
E:00
- The appliance door is open or not
closed correctly or it does not fill with wa-
ter.
•
E:01
- The appliance continuously fills
and drains the water or it does not drain
or do the spinning phase.
•
E:02
- Technical malfunction, contact the
service centre.
•
E:03
- Technical malfunction, contact the
service centre.
Warning!
Deactivate the appliance
before you do the checks.
Problem
Possible cause
Possible solution
The appliance does not
start.
The mains plug is not connec-
ted in the mains socket.
Put in the mains plug.
The fuse in the box fuse is
damage.
Replace the fuse.
The appliance door is open.
Close the door firmly.
You do not press the start but-
ton
Press the start button.
The programme knob is not in
the correct position.
Turn the programme knob in the correct
position.
The delay start is set.
It is available only for models
with the Delay start.
To start immediately the programme,
cancel the delay start.
The appliance does not
fill with water.
The water tap is closed.
Open the water tap.
The water inlet hose is dam-
aged.
Make sure that the water inlet hose has
no damages.
The filter in the water inlet
hose is blocked .
Clean the filter. Refer to 'Care and clean-
ing'.
The water tap is blocked or
there is limescale on it.
Clean the water tap.
electrolux
15
Summary of Contents for EWS 103417 A
Page 1: ...EWS 103417 A EN WASHING MACHINE USER MANUAL ...
Page 21: ...electrolux 21 ...
Page 22: ...22 electrolux ...
Page 23: ...electrolux 23 ...
