ENGLISH
15
12. Cancelling a programme
Turn the selector dial to
O
to cancel a programme
which is running. Now you can select a new
programme.
13. How to open the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off turning the
selector dial to
O
. After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!). To restart the programme switch on
the machine and select again the desired
programme and options. Press START/PAUSE
button
.
13. At the end of the programme
The washing machine stops automatically.
If the Rinse hold
option has been selected, the
door is locked, the light of the START/PAUSE button
goes off,
and
remain lit, to indicate that the
water must be drained before opening the door.
Turn the programme selector dial to Reset
O
to
switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
7. Select the desired options
The light corresponding to the depressed button
illuminates.
8. Select the DELAY START option
To delay starting of a programme, press the DELAY
START button, before starting the machine, until the
light corresponding to the required delay illuminates.
9. Start the programme
Press the START/PAUSE button
. The relevant
light will stop flashing. and only the light relevant to
the phase that is in progress will remain lit.
If you have selected the DELAY START, the machine
starts its hourly countdown.
10. Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to
O
and then you can select the new programme. Start it
by depressing the START/PAUSE button
.
11. Interrupting a programme
Depress the START/PAUSE button
to interrupt a
programme which is running, the corresponding
light starts to flash. Depress the same button again
to restart the programme.
9
h
6
h
3
h
132988520 GB.qxd 19/07/2004 09.12 Pagina 15
