Electrolux EWN 148641 W, User Manual

Page: 13 / 32

If you have chosen a delayed start, the ap-
pliance will begin the countdown.
Altering an option or a running
programme
It is possible to change only the options vi-
zualised on the display by pressing the but-
tons
5 ( Up or Down ) before the programme
carries them out. Before you make any
change, you must pause the appliance by
pressing the button
7 .
Changing a running programme is possible
only by resetting it . Turn the programme
selector dial to O and then to the new pro-
gramme position, press the button 6 to can-
cel the previous washing programme. Start
the new programme by pressing the button
7 again. The washing water in the tub will not
emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme
which is running, the corresponding light
starts blinking. Press the button again to re-
start the programme.
Cancelling a programme
Turn the selector dial to O and then in the
new selected programme. Press the button
6 to cancel the programme which is running.
Now press the button 7 to start the new pro-
gramme.
Opening the door after the programme
has started
Press the button 7 to set the machine to
pause. The corresponding message will ap-
pear on the display.
If the door cannot be opened, this means
that the appliance is already heating, that the
water level is above the bottom edge of the
door.
In this case the door can not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
O . After some mi-
nutes the door can be opened ( pay atten-
tion to the water level and temperature! ).
At the end of the programme
The machine stops automatically.
If the
Rinse Hold or Night Cycle options
have been selected, the pilot light of button
7 goes off, the icon of the selected pro-
gramme and the message «Finished» ap-
pears on the display and the door remains
locked to indicate that the water must be
emptied out before opening the door.
To empty out the water :
• select the draining or spinning programme
• reduce the spin speed if needed, by
means of the relevant button
• press button 7
• at the end of the programme, the display
shows the (Door) icon and alternately
says that the door is unlocked and that the
door is finished. The door can be opened.
Turn the programme selector dial to O to
switch the appliance off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew and
unpleasant smells.
Stand by
Stand by : once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display
is reduced. By pressing any button the ap-
pliance will come out of the energy saving
status.
Helpful hints and tips
Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer’s washing
instructions. Sort the laundry as follows:
whites, coloureds, synthetics, delicates,
woollens.
electrolux 13