When the appliance is in use and depend-
ing on the programme selected there can
be hot water in the pump.
Never remove the pump cover during a
wash cycle, always wait until the appliance
has finished the cycle, and is empty. When
refitting the pump cover, ensure it is secure-
ly re-tightened so as to stop leaks and
young children being able to remove it.
Cleaning the water inlet filters
If you notice that the machine is taking lon-
ger to fill, check that the filter in the water in-
let hose is not blocked.
1. Turn off the water taps.
2. Unscrew the water inlet hoses.
3. Clean the filters in the hose using a hard
bristle brush.
4. Screw the hoses back onto the tap.
5. Unscrew the hoses from the machine.
Keep a rug nearby because some water
may flow.
6. Clean the filters in the valves with a stiff
brush or with the piece of cloth.
7. Screw the hoses back to the machine
and make sure the connection is tight.
8. Turn on the water taps.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water taps;
3. if necessary, wait until the water has
cooled down;
4. open the pump door;
5. place a bowl on the floor and place the
end of the emergency emptying hose in-
to the bowl. Remove its cap. The water
should drain by gravity into the bowl.
When the bowl is full, put the cap back
on the hose. Empty the bowl. Repeat
the procedure until water stops flowing
out;
6. clean the pump if necessary as previous-
ly described;
7. replace the emergency emptying hose
in its seat after having plugged it;
8. screw the pump again and close the
door.
Frost precautions
If the machine is installed in a place where
the temperature could drop below 0°C, pro-
ceed as follows:
1. close the water taps and unscrew the
water inlet hoses from the taps;
2. place the end of the emergency empty-
ing hose and that of the inlet hoses in a
bowl placed on the floor and let water
drain out;
electrolux
19