Technical Support - MDM
38/97
599 76 11-68 Rev. 01
9.2 Description of options
Rinse hold
During the cycle the intermediate rinses and spins are performed.
Stops the appliance with water in the tub before the final spin cycle.
To drain the water, simply press the START/PAUSE button to run the drain and spin cycles.
Pre-wash
Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
In COTTON and SYNTHETICS cycles, performs a short spin before passing on to the washing phase.
This option cannot be selected for WOOL and HAND WASH cycles.
EXTRA-rinse
Add
two
rinses to the cycles where featured.
Eliminates the spin at the end of washing.
ENABLING/DISABLING EXTRA RINSE USING A COMBINATION OF SENSORS
Appliances which do not envisage the SUPER RINSE option combined with a button can enable it through
a sensor combination.
TC4
TC3
During the selecting phase, touch the two sensors shown in the figure simultaneously for a few seconds until
the related icon lights up. This option also remains enabled during subsequent cycles. To disable it, repeat
the same operation until the related icon is turned off.
No spin
It eliminates all the spin phases.
It adds three rinses to the COTTON cycle and one to the SYNTHETIC FABRICS cycle.
TM5-6-7-8
Modifies the structure of the COTTON
– SYNTHETIC FABRICS – DELICATES cycles to obtain good
washing performance in a variable amount of time.
TM2-3-4
Modifies the structure of the wash phase of the COTTON
– SYNTHETIC FABRICS – DELICATES cycles
by half a load.
TM1
Modifies the structure of the wash phase of the COTTONS
– SYNTHETICS – DELICATES cycles by 1 Kg
of laundry.
Delayed start time
Adds a pause before the start of the programme. The delay time is shown on the three digit display.
During the programme selection phase, a delayed start can be selected, from 30’ to 20 hours (30’
60’
90’
2h
3h…
20h
0h) and the time is shown on the display; during the last one, the time
decreases one minute at a time.
To start the cycle immediately after the countdown to the delayed start has already begun:
press the Start/Pause button, cancel the delay time by pressing the relevant button, then press
Start/Pause again.
