Technical Support - MDM
23/97
599 76 11-68 Rev. 01
4.3.3.4
Sensors
– LEDs and LCD
The functions of each button are defined by the configuration of the appliance.
Button no. 1
: ON/OFF - ON
Press it to turn the appliance on, at the same time the buzzer will
sound a tone (if enabled), all the LEDS around the selector dial will
light up for an instant and the LCD display stays off (figure above).
When the initial phase has ended, only one LED remains lit and the
LCD display shows the basic settings of a programme (figure below).
The operation of the ON/OFF depends on the configuration of the
main circuit board. It can cut the appliance off from the electricity
mains completely (0 Watt circuit) or set the appliance to low energy
consumption mode (without 0 Watt circuit) in which case you will need
to take the plug out of the socket to cut off the electricity supply
completely.
Press the ON/OFF button to cancel the chosen programme.
Button no. 1:
ON/OFF - OFF
To turn the appliance off, press this button and hold it down for
approximately 1 second, after this time the buzzer will sound a tone
(if enabled), all the LEDS around the selector dial will light up for an
instant (figure above), the LCD display shows the programme
settings, then the following switch off: the EDS around the selector
dial, the Start/Pause LED, the LCD display (figure below).
Sensor no. 2:
TEMPERATURE
This is related to the part of the LCD display in which the washing
cycle temperature is shown.
The starting temperature shown on the LCD display is the one set
for the programme selected.
Touch the sensor (represented by the thermometer symbol) in
sequence to lower the temperature. Once the lowest temperature
has been reached, the selection starts off again from the highest
one available for that particular programme.
The temperatures available (displayed in °C) are:
90°C, 60°C, 50°C, 40°C, 30°C, 20°C, cold cycle
.
The cold cycle is displayed by two dashes .
P1
P1
S2
