background image

         www.electrolux.com 

For the correct functioning of the 

machine, the drain hose must 

remain hooked on the proper 

support piece situated on the top 

part of back side of the appliance.

90 cm

60 cm

This machine is designed to 

operate on a 220-240 V, 

single-phase, 50 Hz supply.

11.

5

 Electrical Connection

“An incorrect power supply may 

void your warranty.”

Check that your domestic electrical 

installation can take the maximum 

load required (2.1 kW), also taking 

into account any other appliances 

in use.

The manufacturer declines any 

responsibility for damage or injury 

through failure to comply with the 

above safety precaution. 
Should the appliance power supply 

cable need to be replaced, this 

shall be carried out by our Service 

Centre.
When the appliance is installed, 

the power supply cable must be 

easily accessible. 
If this appliance is supplied from a 

cord extension set or electrical 

portable outlet device, the cord 

extension set or electrical portable 

device must be positioned so that 

it is not subject to splashing or 

ingress of moisture.

Connect the machine to 

an earthed socket outlet. 

CAUTION!

Summary of Contents for EWF12033

Page 1: ...hown 1 Remove the carton box Remove the polystyrene packaging materials Remove the plastic bag which cover the machine 2 Open the door Remove the polystyrene piece from the door seal and all the items from the drum 3 7 Remove the power supply cable and the drain and inlet hoses from the hose holders A on the rear of the appliance 1 2 You are advised to keep all transit devices so that they can be ...

Page 2: ... when in operation 11 2 Positioning Use a spirit level on the top and side of the washing machine to check the levels If you do not have a spirit level as a guide use the edge of a door frame cupboard or bench to check that the washing machine is leveled It is important that your washing machine stands firm and leveled on the floor to ensure correct operation The appliance must not be installed be...

Page 3: ...units The inlet hose must not be lengthened If it is too short and you do not wish to move the tap you will have to purchase a new longer hose specially designed for this type of use This could be done by tying it to the tap with a piece of string or attaching it to the wall In a sink drain pipe branch This branch must be above the trap so that the bend is at least 60 cm above the ground Directly ...

Page 4: ...aking into account any other appliances in use The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution Should the appliance power supply cable need to be replaced this shall be carried out by our Service Centre When the appliance is installed the power supply cable must be easily accessible If this appliance is supplied from a co...

Reviews: