ENGLISH 25
The end of the drain hose is too low. (Error code: ) => Refer to
relevant paragraph in “water drainage” section.
The machine fills
then empties
immediately:
Certain problems are due to lack of
simple maintenance or oversights,
which can be solved easily without
calling out an engineer.
Before contacting your local Service
Centre, please carry out the checks
listed below. During machine operation
it is possible that the red Start/Pause
pilot light flashes to indicate that the
machine is not working.
Once the problem has been eliminated,
press the Start/Pause touchpad to
restart the program. If after all checks,
the problem persists, contact your local
Service Centre.
The appliance does not fill
with water properly.
The appliance door is open or
not closed correctly. Please
check the door!
The appliance does not drain
the water.
The mains supply is unstable.
Wait until the mains supply is
stable.
No communication between
electronic elements of the
appliance. Switch off and
switch on again.
With some problems, the acoustic
signals operate and the display
shows an alarm code:
TROUBLESHOOTING
9.
WARNING! Deactivate the
appliance before you do the
checks.
Possible failures
The door has not been closed. (Error code: ) => Close the
door firmly.
The plug is not properly inserted in the power socket. => Insert the
plug into the power socket.
There is no power at the socket. => Please check your domestic
electrical installation.
The Start/Pause touchpad has not been pressed. => Press the
Start/Pause touchpad.
The “Delay End” has been selected. => If the laundry are to be
washed immediately, cancel the “Delay End”.
The inlet hose is squashed or kinked. (Error code: ) => Check
the inlet hose connection.
The filter in the inlet hose is blocked. (Error code: ) => Clean
the water inlet hose filter.
The door is not properly closed. (Error code: ) => Close the
door firmly.
The water tap is closed. (Error code: ) => Open the water tap.
The washing
machine does
not start:
The machine
does not fill the
water:
Malfunction
Possible cause => Solution
The main supply is unstable. (If appears in the display.) => Wait
until the main supply is stable and the appliance automatically starts
operating.
