Problem
Possible solution
There is water on the floor.
Make sure that the couplings of the water hoses are tight and there is
not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct quantity of
it.
You cannot open the appli-
ance door.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
The appliance makes an
unusual noise.
Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion'.
Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
The appliance fills with wa-
ter and drain immediately.
Make sure that the drain hose is in the correct position. The hose
may be too low.
The washing results are not
satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash
the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes. De-
activate and activate the appliance. If the
problem continues, contact the Service.
TECHNICAL INFORMATION
Dimensions
Width / Height / Depth
600 / 850 / 522 mm
Total depth
540 mm
Electrical connection:
Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture
IPX4
Water supply pressure
Minimum
0,5 bar (0,05 MPa)
Maximum
8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum load
Cotton
8 kg
Spin speed
Maximum
1200 rpm
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
electrolux
19
