Electrolux EW9W8862E9, User Manual

Page: 5 / 60

side, that would prevent the appliance door from being
fully open.
•
Connect the mains plug to the mains socket only at
the end of the installation process. Make sure that the
mains plug is accessible after installation.
•
The ventilation opening in the base must not be
covered by a carpet, mat, or any floor covering.
•
WARNING: The appliance must not be supplied
through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on
and off by a utility.
•
Ensure good air ventilation in the room where the
appliance is installed to avoid the backflow of
unwanted gases into the room from appliances
burning gas or other fuels, including open fires.
•
Exhaust air must not be discharged into a flue which is
used for exhausting fumes from any appliances
burning gas or other fuels.
•
The operating water pressure at the water entry point
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
•
The appliance maximum load is 10 kg. Do not exceed
the maximum load of each programme (refer to the
"Programmes" chapter).
•
The appliance must be connected to the water mains
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
•
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
•
Wipe away lint or packaging debris that has
accumulated around the appliance.
•
Do not run the appliance without filters. Clean the lint
filter before or after each use.
•
Items that have been soiled with substances such as
vegetable or mineral oil, acetone, alcohol, petrol,
ENGLISH 5