8
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
10.
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements or burners. They may be hot
enough to cause burns.
Remove all packaging from the oven before testing.
1. Install Burner Caps and Triple burner head
This cooktop is equipped with sealed burners.
A. Unpack the burner grates.
B.
Regular Burners
: Burner heads and burner caps are
already on the surface. Remove all tapes from burner
caps and verify if they are correctly place on the
burner heads (see Figure 10).
C.
Triple Burner (if equipped)
: Remove all tapes from
burner cap. Remove the burner cap and head.
Remove and discard the packaging material. Replace
head and cap on the triple burner.
Be careful not to
damage the electrode while placing the head
over the orifice.
Make sure electrode fits correctly
into slot in burner head (see Figure 11).
D. Be sure that all the burner caps and the triple burner
head are correctly placed BEFORE using your cooktop.
NOTE:
There are no burner adjustments necessary on this
cooktop.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
Figure 9
Models Equipped with Leveling Device
Level the range after installation in the cutout
opening.
1.
Open the range drawer. The leveling screws control
the height of the rear leg.
2.
Adjust the appliance legs as follows until the
underside of the cooktop surface is sitting level on
the countertop (Figure 8).
a.To adjust the front legs, use a wrench on the leg
base and turn clockwise to lower or
counterclockwise to raise.
b.To adjust the rear legs, use a ratchet or a
nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to raise.
3.
Check if the range is level by installing an oven rack
in the center of the oven and placing a level on the
rack (Figure 9).
4.
Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5.
If the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
9.
Leveling the Range
RAISE
LOWER
RAISE
RAISE
LOWER
LOWER
Font
Leveling
Leg
Leveling
Screw
Use this Screw
to Adjust Rear Leveling
Device Height
Rear Leveling
Device
Figure 8
Figure 10
Burner Cap
Burner Head
Electrode
Gas Opening
