warm water with a little washing-up liquid
added.
After cleaning, reconnect the equipment to
the mains supply.
DEFROSTING THE FREEZER
A certain amount of frost will always form
on the freezer shelves and around the top
compartment.
Defrost the freezer when the frost layer rea-
ches a thickness of about 3-5 mm.
To remove the frost, follow the instructions
below:
• switch off the appliance and pull out the
plug from the wall socket
• remove any stored food, wrap it in sever-
al layers of newspaper and put it in a cool
place
• remove the freezer drawers
• put insulating material around the draw-
ers, e.g. blankets or newspapers.
Defrosting can be accelerated by placing
bowls with hot water (not boiling) inside the
freezer.
• Leave the door open and insert the plas-
tic scraper in the appropriate seating at
the bottom centre, placing a basin under-
neath to collect the defrost water
• carefully scrape off the ice when it starts
to thaw (use a wood or a plastic scraper)
• when all the ice has melted, dry the interi-
or thoroughly and keep the scraper for
future use.
• switch on the appliance and replace the
frozen foodstuff.
It is recommended to operate the appliance
at the highest position of the thermostatic
control for some hours so that it can reach
the sufficient storing temperature as soon
as possible.
Caution!
Never use sharp metal tools
to scrape off frost from the evaporator
as you could damage it. Do not use a
mechanical device or any artificial
means to speed up the thawing
process other than those
recommended by the manufacturer. A
temperature rise of the frozen food
packs, during defrosting, may shorten
their safe storage life.
WHAT TO DO IF…
Warning!
Before troubleshooting,
disconnect the mains plug from the
mains socket.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Problem
Possible cause
Solution
The appliance does not
operate. The Pilot light
does not flash.
The appliance is switched off.
Switch on the appliance.
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
The Pilot light flashes.
The appliance is not working
properly.
Contact a qualified electrician.
electrolux
7
