Electrolux EU 6047T, Installation And Instruction Manual

Page: 18 / 24

Door Reversal
1. Disconnect the appliance from the electricity
supply.
2. Remove all loose items, including food. Store
food in a cool place.
3. Make sure a towel or cloth is at the base of
the product to prevent it from slipping.
4. Carefully lean the appliance backwards,
resting the top on a stool, or something
similar, at least 30cm (12") from the floor.
(care must be taken not to allow the appliance
wheels to slip).
Do not support the appliance on the rear
ventilation grille or condenser.
5. Remove level adjuster (A) from base of
product retaining small cup spacer which is
located around the threaded portion of the
adjuster.
6. Remove the foot / hinge assembly (B) by
removing screws marked (C).
7. Remove the door by lifting it slightly and
carefully sliding it down off the top hinge pin
(F) by removing screw (G) and transfer to the
opposite side.
8. Refit the door by carefully sliding it onto the
upper hinge pin (F). Take the bottom hinge
foot assembly (B) and transfer it over to the
opposite side of the cabinet being careful to
retain any spacing washer fitted onto the
bottom hinge pin. Push the hinge foot
assembly (B) into the door bearing using the
pin of the foot for location. Three holes will
then line up with the hinge foot and screws (C)
should be used to secure the hinge.
9. Refit level adjuster in the opposite side of the
cabinet.
The base of your product should now be in
line with the diagram.
10. Stand the appliance upright.
18
B
C
A