Do not use gas other than that which is specified on the
label attached.
do not place anything, e.g. flame tamer, asbestos mat,
between appliance and pan support as serious damage
to the appliance may result. (Fig 1)
Do not remove the pan support and enclose the burner
with a wok stand not supplied by Electrolux as this will
concentrate the flame and deflect the heat onto the top
plate. (Fig 2)
Do not use large pots or heavy weights which can bend
the pan support or deflect the flame onto the top
plate. (Fig 3)
Locate pan centrally over burner so that it is stable and
does not overheat the appliance. (Fig 4)
Use only wok support supplied or recommended by the
manufacturer of the appliance ( Fig 5)
The unit to be used for cooking only, do not
dry towels, clothes, etc., over it, if this is done, there is
danger for fire if a gas leak is found, close stop cock,
open up all windows and call your dealer, do refrain from
turning an electric switch on or off, lighting a match
smoking or using a lighter.
Use the appliance in a well ventilated room.
Do not use vinyl gas hose. It is liable to be softened
by heat, use only a rubber hose.
Be sure to turn off the ignition knob and regulator of
the cylinder after use.
Avoid touching the burner, pan stand etc., immediately
after use. Otherwise you will get hurt.
Ensure that the rubber hose does not touch any part of
the unit or lies underneath it.
Connect the rubber hose to the gas inlet and fasten it
with a hose clamp.
The pan stand leg nearest to the flame will have
discolorations after use. Such phenomenon is normal.
SAFE INSTRUCTIONS
In the event of burner flame
being accidently extinguished,
turn off the burner control knob
and do not attempt to re ignite
the burner for at least 1 minutes.
For burner fitted with a flame
supervision device, if after 15
seconds of ignition operation the
burner has not lit, stop operating
the device and open the
compartment door and wait at least
1minute before attempting a further
ignition of the burner.
If nozzle holes are blocked,
use a thin wire or pin to pierce and
clean the nozzle holes.
WARNING:
