Electrolux ESL64010, User Manual

Page: 13 / 48

first use electrolux 13
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically, using
some of the programme buttons on
the control panel
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at
level 5.
1. Press the On/Off button. The
dishwasher must be in setting
mode.
2. Press simultaneously and keep
pressed buttons 2 and 3, until the
lights of buttons 1, 2 and 3 start
flashing.
3. Press button 1, the lights of
buttons 2 and 3 turn off while the
light of the button 1 goes on
flashing, at the same time the end
of programme indicator light
starts to flash, along with a
sequence of intermittent audible
signals.
The current level is indicated by
the number of flashes of the end
of programme indicator light (see
chart) together with a sequence of
intermittent audible signals and a
pause of a few seconds.
Examples:
5 flashes / 5 intermittent audible
signals, pause, 5 flashes / 5
intermittent, pause, etc... = level 5
6 flashes / 6 intermittent audible,
pause, 6 flashes / 6 intermittent
audible, pause, etc... = level 6
4. To change the level, press button
1. Each time the button is pressed
the level changes. (For the
selection of the new level see the
chart).
117992 59/0en 4-12-2006 10:01 Pagina 13