13
A
D023
D
C
D723
D724
Gerät in die Nische einschieben bis die
Anschlagleiste (A) unten am Möbel anliegt.
Tür öffnen und Gerät gegenüber der Bandseite an
die Möbelseitenwand anrücken. Gerät mit den 4 bei-
liegenden Schrauben befestigen.
Belüttungsgitter (C) und Scharnierabdeckung (D)
aufstecken.
Fugenabdeckprofiloben um die Winkeldicke
ausschneiden und zwischen Gerät und Möbelseiten-
wand eindrücken.
D726
B
PR266
A
B
C
D
In die Befestigungsund Scharnierlöcher beiliegende
Abdeckkappen (B) eindrücken.
Die Teile A, B, C, D abnehmen, wie in der Abb.
gezeigt wird.
16
CONTENTS
Warnings
15
Use
17
Cleaning the interior
17
Operation
17
Temperature regulation
17
Fresh food refrigeration
17
Freezing fresh food
18
Storage of frozen food
18
Thawing
18
Ice-cube production
18
Movable shelves
19
Positioning the door shelves
19
Hints
20
hints for refrigeration
20
Hints for freezing
20
Hints for storage of frozen food
20
Maintenance
21
Periodic cleaning
21
Periods of no operation
21
Interior light
21
Defrosting
21
Customer service and spare parts
22
Technical information
23
Installation
23
Location
23
Electrical connection
23
Changing the opening direction of the doors
24
Instructions for totally built-in
24
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important:
if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol
are recyclable.
