Electrolux EOC5650AA, User Manual

Page: 30 / 36

1
2
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point
to the front.
10.3
Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3" when
this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same cabinet,
do not use them at the same
time as the Pyrolysis function.
It can cause damage to the
appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When flashes, press or to
set the necessary procedure:
Option Description
P1 If the oven is
not very dirty.
Time of the
procedure: 1
h 30 min.
P2 If you cannot
easily remove
the dirt. Time
of the proce-
dure: 2 h 30
min.
After 2 seconds the procedure starts.
You can use the End function to delay the
start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. To change the default length of the
procedure (
P1 or P2 ), press to set
, and then press or to set
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
display shows the symbol and the
bars of the heat indicator until the
door unlocks.
7. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
10.4 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press and at
the same time while PYR
flashes in the display.
www.electrolux.com 30