30
E
EM
MS
S 2
24
48
85
5
U
UK
K
1. Remove any promotion label from the door.
2. This oven can be used as a free standing oven or
built-in, into a kitchen cabinet using kit number BF
246. To install the oven in a kitchen cabinet follow the
instructions supplied with the building-in kit.
The oven should be installed on a flat, level surface. The
surface must be strong enough to safely bear the
weight (18 kg) of the oven, and the contents. To avoid
the possibility of causing vibration or noise the oven
must be in a stable position.
3. Keep the oven away from heat and water. Exposure to
heat and water can lower oven efficiency and lead to
malfunctioning, so be sure to install the oven away
from heat and water sources.
4
. Do not block air vents on the top and the sides of the
cabinet and also do not place any articles on the top
of the oven. A gap all around the oven is necessary :
140 mm above the oven and any objects, 50 mm on
the sides and 100 mm behind the oven. If air vents
are blocked during operation, the oven may overheat,
and this may lead to malfunctioning. Hot air escapes
from the vents, so be sure not to obstruct it or let cur-
tains come between the oven and the rear wall.
5. Place the oven as far away from radios and TVs as
possible. This oven does conform to EEC require-
ments* of radio interference suppression, but some
interference may occur if it is placed too close to a
radio or TV, so keep them as far apart as possible.
6. If positioned in a corner, leave a gap of at least
5 cm from the right side wall.
IMPORTANT!
The oven can be placed almost
anywhere in the kitchen. Make sure the oven is
placed on a flat, level surface and that vents as
well as the surface underneath the oven are not blocked
(for sufficient ventilation).
Electrical connections
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability
should this safety measure not be observed.
f the plug that is fitted to your appliance is not suitable
for your socket outlet, it must be cut off and the appro-
priate plug fitted.
Remove the fuse from the cut off plug. The cut off
plug should then be disposed of to prevent the hazard
of shocks in case it should be plugged into a 13 Amp
socket in another part of your home.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
GREEN AND YELLOW
EARTH
BLUE
NEUTRAL
BROWN
LIVE
If you fit your own plug, the colours of the wires in the
mains lead of your appliance may not correspond with
the markings identifying the terminals in your plug,
proceed as follows:
Connect the green and yellow (earth) wire to the termi-
nal in the plug which is marked with the letter E or the
earth symbol (
) or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter N or coloured
black.
Connect the brown (live) wire to the terminal in the plug
which is marked with the letter L or coloured red.
!
F
Fo
orr tth
he
e iin
ns
stta
alllle
err
13 AMP FUSE
BLUE
GREEN & YELLOW
BROWN
CORD CLAMP
