33
100
650
100
100
500
650
500
Location
Carry out installation as described in the
Installation Requirement chapter-paragraph 2.4 of
AG 101-2000.
Choose a location free of draughts and open doors and
clear of combustible materials or other fire hazards such
as curtains, etc.
The location should ensure convenience of operation and
service. Any adjacent wall surface situated within 200
mm from the edge of any hob burner and above the height
of the hob must be a suitable non-combustible material
for a height of 150 mm for the entire depth and width of
the cooker. If the hob is below the bench top, a clearance
of 100 mm must be provided.
Any combustible material above the hotplate must be at
least 650 mm above the top of the hob and no
construction shall be within 450 mm above the top of the
burner.
40mm
Fitting the Stability Bracket
In order to prevent accidental tipping of this
appliance, for example by a child climbing on to
the open oven door, the stabilising means MUST be
correctly installed, as per instruction below:
1. Place the cooker in its intended position and mark
the cooker height, taken from the top of the trivets
(splashback removed), and mark floor fixing holes on
ground.
2. Mark 750 mm below the cooker height. This is the
position of the stability bracket (position of the stability
bracket does not have to be centrally located).
3. Attach the stability bracket flush with the wall using
appropriate screws & fixing as pictured (not nylon
plugs supplied may need to be trimmed flush with
the wall to get the bracket flush with the wall). Ensure
that at least one of the fixing screws is at the bottom
of the slot in the bracket so that it can’t slide up
when screws are loose.
4. Pull the cooker towards the rear wall as shown in the
diagram. The stability bracket should then come into
contact with the bottom panel of the cooker.
5. Screw the floor brackets to the floor using appropriate
screws and or fixing devices to lock the cooker in
place.
Check that the stability bracket securely prevents the
cooker from accidently tipping forward when a downward
force is applied to the open oven door.
SIDE VIEW
OF THE COOKER
BASE OF COOKER
ENGAGEMENT EDGE FOR
STABILITY BRACKET
BACK OF COOKER
720mm
750mm
