85
Something not working
"
"
"
"
"
The flow of gas seems abnormal
"
"
"
"
"
Gas smell in the room
"
"
"
"
"
The oven doesn't heat
"
"
"
"
"
Cooking time is too long
"
"
"
"
"
The cooker produces smoke
"
"
"
"
"
The oven lamp doesn't work
"
"
"
"
"
The display shows "12.00". 8-1503
If the appliance doesn't work properly check the following points before asking for service:
Make sure that:
— the flame speader holes are not obstructed;
— the pressure regulator is working;
— the bottle valve is completely open.
Make sure that:
— the gas valve is not open;
— the gas supply tube is well positioned and in good
condition; remember to replace it at least once a
year.
Never look for an escape of gas with a match;
use instead soapy water.
— Make sure that the oven knobs are in the correct
worrking positions.
— Check that the temperature is correct for the type
of food to be cooked.
— We advise you to clean the oven after use.
Splashes of fat can occur during the cooking of
meat and, if the oven isn't cleaned properly, these
produce smoke and bad smell. (see paragraph
concerning cleaning).
— The lamp has burnt out. To replace it follow the
instructions given in the relative paragraph.
— Set the time of day (see chapter "How the set the
time of day").
If, after following all the above checks the appliance still doesn't work, call your nearest Service Centre givin them all
the necessary information, such as model and serial number of the appliance.
Original spare parts
If after the checks listed in the previous chapter, the
appliance still does not work correctly, contact your
locals Service Centre, specifying the type of
malfunctioning, the appliance model (Mod.), the product
number (Prod. No.) and the serial number (Ser. No.)
marked on the identification plate.
This plate is placed on the front external edge of the oven
cavity.
Original spareparts, certified by
the product manufacturer and
carrying this symbol are only
available at our Service Centre
and authorized spareparts
shops.
Maintenance - Technical assistance
The gas cocks must be periodically lubricated to ensure
good working and safety.
Maintenance should be performed as follows:
•
Remove the knob and panel after having taken out
fastening screws.
•
Loosen the two screws located at the sides of the
cock bar.
•
Remove the cone and clean it carefully.
•
Then, apply a thin layer of grease non soluble in water,
suitable for gas cocks. Take care not to obstruct the
gas flow holes by an excess of grease.
Reassemble the whole with utmost care performing the
operations described above inversely.