30
Changing The Water and Air Filters
Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all
dispensed drinking water, as well as the water used to
produce ice. The air filter removes odors and impurities
from the refrigerator compartment.
Push Water Filter Button
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.
About your advanced water filter
The
PureAdvantage
TM
NGFC 2000 ice and
water filter system is tested and certified by
NSF International to NSF/ANSI Standards 42
and 53 for the reduction of claims specified on
the performance data sheet.
Water filter
The water filter is located at the lower left side of the
fresh food compartment.
Replacing your
PureAdvantage
TM
water filter
In general, you should change the water filter every
six (6) months to ensure the highest possible water
quality. The
Water
Filter Status
light on the Touch Panel
prompts you to replace the filter after a standard amount
of water (400 gallons)
has flowed through the system.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replacement.
1
Turn
Off
the ice maker on the control panel.
2
Push the filter release button above the cartridge
to disconnect it.
3
Slide the old water filter cartridge straight out of
the housing and discard it.
4
Unpack the new filter cartridge and remove the
two (2) protective caps covering the inlet and exit
of the filter. Slide the filter gently into the housing
until it stops against the snap-in connector at the
back of the housing.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
• Rated Capacity - 400 gallons for
PureAdvantage
TM
ice and water filter
• Rated service flow - .5 gallons per minute
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
5
Push firmly until the cartridge snaps into
place (you should hear two clicks).
When fully
engaged, the front of the filter cartridge should be
flush with the filter release button.
Reinstall Water Filter
6
Turn
On
the ice maker at the control panel.
7
Press a drinking glass against the water
dispenser while checking for any leaks at the filter
housing. Spurts and sputters may occur as the
system purges air out of the dispenser system.
8
Prime the water supply system as described
previously.
9
Press and hold the
Filter Status
button on the
control panel for three (3) seconds. When the
display changes from
Replace
to
Good
, the
status has been reset.