Electrolux EHC321BA, User Manual

Page: 12 / 28

EEH354C
ware may be knocked o ff the rings when
doors and windows are opened.
Caution! Warning! Risk of injury
from electrical current.
t The electrical mains terminal is live.
t Make electrical mains terminal free of volt-
age.
t Follow connection schematic.
t Observe electrical safety rules.
t Ensure anti-shock protection by installing
correctly.
t The appliance must be connected to the
electrical supply by a quali fi ed electrician.
t Loose and inappropriate plug and socket
connections can make the terminal over-
heat.
t Have the clamping connections correctly
installed by a quali fi ed electrician.
t Use strain relief clamp on cable.
Caution! The surface temperature
exceeds 95°C. To avoid a hazard,
underbench access must be restric-
ted
Electrical Connection
Before connecting, check that the nominal
voltage of the appliance, that is the voltage
stated on the rating plate, corresponds to the
available supply voltage. Also check the
power rating ofthe applianceand ensurethat
the wire is suitably sized in accordance with
local wiring rules to suit the appliance power
rating. The rating plate is locatedon the lower
casing of the hob. Means for disconnection
must be incorporated in the fi xed wiring in
accordance with local wiring rules.The hob
is to beconnected to the mains using a device
that allows the appliance to be disconnected
from the mains at all poles with a contact
opening width of at least 3 mm, eg. auto-
matic line protecting cut-out, earth leakage
trips or fuse. If this appliance’s mains cable
is damaged, it must be replaced by a special
cable (type H05BB-F Tm ax 90°C; or higher).
The latter is available from the Customer
Care Department. The connection must be
carried out as shown in the diagram.
The earth lead is connected to termi-
nal
. The earth lead must be longer than
leads carrying electric current. The cable
connections must be made in accord-
ance with regulations and the terminal
screws tightened securely. Finally, the
connecting cable is to be secured with the
mains cable cleat and the covering closed by
pressing fi rmly (lock into place). Before
switching on for the fi rst time, any protective
foil or stickers must be removed from the
glass ceramic surface.
Warning! Once connected to the
mains supply check that all cooking
zones are ready for use by brie fl y
switching each on in turn at the
maximum setting.
t A duplicate rating label is supplied
with this unit. For easy identi fi cation of
this unit after installation, stick it to a
readily available surface adjacent to
the cooktop.
Sticking on the seal
t Clean the worktop around the cutout area.
t Stick the single-sided adhesive sealing
tape provided on the underside of the hob
around the outside edge ensuring that it is
not stretched. The two ends of the tape
should join in the middle of one side. After
trimming thetape (allow itto overlapby2-3
mm), press the two ends together.
12 electrolux