16
Installation
1. Cut out worktop to prescribed measurements (fig.1) or
templates (saw exactly along the scribing) and fasten
the fixing springs in the cutout with the enclosed
screws. Position the springs according the enclosed
template. The upper part of the ressort is the spacing
stop.
2. The working plate must be clean. Check seal for
perfect fit and overall cover. Lower the ceramic hob into
the cut-out. Press firmly on one side then on the
opposite side to snap-in the unit.
A sealing is glued onto the frame so there is no need
for further sealing material (important for the removal
in case of a defect).
The installation of the corresponding control box or oven
will be carried out according to separate instuctions. In
order to protect the appliance from damage only ovens
or control boxes which are approved by the manufacturer
must be connected to the ceramic hob.
The installation of electrical appliances must be
undertaken by qualified electricians only. Improper
repairs can cause serious harm and danger for
users. The protection against accidental contact
must be ensured by proper installation.
Attention:
If installed in stone, ceramic tiles or lava
worktops, the fixing ressorts will not be fastened. Instead,
silicone will be put under the cover frame. To avoid that
silicone runs down between the glass ceramic hob and
the worktop (fig.3, pos.1) a sealing will be glued to the
ceramic hob (fig.3, pos.2). The sealing can be ordered
free of charge under article no. 374 0161-02.
The distance between the underside of the hob and the
furniture beneath must be
at least 20 mm
(fig.4).
Important for the removal of the hob
1. Disconnect the appliance from the mains.
2. In order to take out the whole glassceramic hob, use
a medium flat screwdriver or spatula. Put it in between
the frame and worktop on the area where the snap-in
ressorts are located.
3. Then slightly lift the unit out. Take care not to damage
the worktop.
Attention:
If there are any repairs to be effected, the
appliance must be
non-tensioned.
If any fissures or cracks appear on the
hob's surface the hob has to be
switched
off immediately
. Disconnect the appli-
ance from the mains and inform the service
department.
In terms of fire protection, the appliance conforms
to Type Y (IEC 335-2-6). Only appliances of this type
may be installed on one side of adjacent upright
furniture housings or walls.
Fig. 1
Fig. 2
sealing
glass ceramic
work top
pos. 1
pos. 2
Fig. 3
Fig. 4
All manuals and user guides at all-guides.com
