13
Unpacking
The fittings supplied to install this cooker
hood can be found with the instruction book
inside the packaging and consists of the
following:
Ducting spigot
Blanking plate
Wall fitting template
Fiting Kit:
2 - Wall fixing brackets
4 - Plastic rawl plugs
4 - Wall bracket fixing screws
2 - Security washers
2 - Security nuts
Fitting the Wall Brackets
1.
Using the paper template provided mark the
hole positions on the wall for the bracket fixing
screws.
2.
Check that the hole distances are correct with
a tape measure as stated on the template.
3.
At this stage it is important to allow 15mm (
1
/
2
)
clear space above the cooker hood to enable it
to be hooked onto the brackets and for
subsequent removal for decorating or
servicing.
4.
Fit the brackets with the round ends facing
downwards using the plastic rawl plugs and
screws provided.
Venting
The hood is more effective when used in the
extraction setting (ducted to the outside).
Venting kits may be purchased through your
retailer or DIY store, and must be ducted to
an outside vent of 100mm (4”) minimum.
The ducting used must be manufactured from
fire retardant material which should conform to
the relevant British Standard or DIN4102-B1.
When the hood is ducted externally the
charcoal filter must be removed and the
slider control must be in the ducting position.
