13
Installation
Mounting accessories included
1 allen spanner (for TORX screws).
4 Spacers
1 screw for coupling ring
4 screws 4,5 x 16 for side fixing
1 Flange Ø120mm
Additional screws may be supplied, this are
supplied for servicing purpose.
Installation
Attention!
Check that, once installed, it is possible to
open the front door (see fig.6) of the hood to
access the motor housing.
Fit the drilling template which comes with the
hood on the inner right side of the cabinet
making sure printed arrow coincides with back
part (Fig. 8).
Make holes as indicated on template (Fig. 8 -
choose 2 of the 3 holes available).
Perform the same operations on the inner left
side.
In case of side panels with a thickness of 16
mm, fit 4 spacers
G
on the slots of the fan
housing used for side fixing (Fig. 9).
Use screws
F
(4.5x16) to fasten the hood to the
cabinet (Fig. 9).
Extractable drawer adjustment
The hood can be installed in cabinets
with different depths, the front of the box must
always be in line with the cabinet.
For alignment adjust the back stops of the drawer
(Fig. 10).
For box adjustment, loosen screws
M
and slide
square plates
P
as necessary and tighten screws
M
.
Connection to the outlet hose
Fix the outlet hose appropriately to the flange on
the upper side of the hood (hose not included, to
be purchased).
Direct the hose outside (Extraction mode).
Fig. 8
1
2
3
4
G
F
Fig. 9
Fig. 10
M
P