high
Recommended for durable fabrics and towels.
normal
Recommended for most cotton fabrics.
low
Recommended for delicate fabrics.
air dry
Uses only ambient air temperature without heat.
Dryness Level (Auto Dry)
To change the preset level, press the
dryness
option button to scroll to the degree of
dryness desired.
To protect your fabrics, not all dryness levels
are available with every cycle. If a dryness level
is not appropriate for the cycle, it cannot be
selected.
• Select the
normal
dry level for most Auto
Dry cycles.
• Occasionally a load may seem too damp
or over-dried at the end of the cycle. To
increase drying time for similar loads in the
future, select
high
.
• For loads requiring less drying time, select
less
.
• Select
damp
for items you wish to partially
dry before hanging or ironing.
Adjusting the remaining moisture
level
Your condensation dryer comes from the
factory pre-set to dry your laundry at a
standard level. If you would like to increase
the dryness level of your laundry, you may
follow these steps to change the default
degree of remaining moisture:
1. Press the
power
button to turn on the
unit.
2. Turn the cycle selector to any dry pro-
gram.
3. Wait approximately 8 seconds.
4. Press and hold the
extended tumble
and
wrinkle release
buttons simultane-
ously for 4 seconds.
WARNING
FIRE HAZARD
To avoid fire hazard, DO NOT dry items
containing feathers or down, foam rubber,
plastics similarly textured, rubber-like materials.
Controls and Settings
One of the following indications will appear on
the display:
• 0- Standard dry level (factory default)
• 1- More dry level (this will increase the
time of each cycle by approx. 10%)
• 2- Max dry level (this will increase the
time of each cycle by approx. 20%)
Please note that this dryness level change will
apply to every dry cycle and cycle settings
combination except for the time dry cycle.
The time dry cycle dryness level and available
cycle times cannot be changed by adjusting
the remaining moisture level setting.
5. Press and hold the
extended tumble
and
wrinkle release
buttons simultane-
ously again for 4 seconds to continue
scrolling through the dryness levels.
Repeat this step until the number of the
desired remaining moisture level appears
in the display.
6. Once the desired remaining moisture
number is shown in the display, wait 5
seconds. The display will then return
to the normal mode and the selected
remaining moisture level will be used for
each future cycle.
Cycle Options
To add options, press the corresponding option
button to illuminate the selection desired. To
delete options, press the option button again
and the indicator light will turn off. If attempting
to select an unavailable setting or option for
any given cycle, a beep will be heard and the
corresponding setting/option LED will not light.
To protect your fabrics, not all options are
available with every cycle. Not all options are
available on every model.
wrinkle release
Select
wrinkle release
if the dried load
might not be removed promptly at the end of
the cycle. This option provides an additional
30 minutes of short intermittent tumbling.
The drum will tumble a few seconds in each
direction, then rest for approximately 30
seconds before repeating. The load may be
removed at any time during
wrinkle release
. A
beep will be heard periodically throughout this
phase if the mute sound option is not selected.
11
Summary of Contents for EFLS210TIS
Page 21: ...21 ...
Page 22: ...electrolux com shop ...
