Electrolux EFC 60652, User Manual

Page: 16 / 24

16 16
16 16 16 electr
electr
electr electr electrolux
olux
olux olux olux installation
GB
Installation Installation Installation Installation Installation
Make sur Make sur
Make sur Make sur Make sure that the cooker hood is disconnected fr
e that the cooker hood is disconnected fr
e that the cooker hood is disconnected fr e that the cooker hood is disconnected fr e that the cooker hood is disconnected from the power supply befor
om the power supply befor
om the power supply befor om the power supply befor om the power supply before
ee
e e
carrying out the installation. carrying out the installation.
carrying out the installation. carrying out the installation. carrying out the installation.
Remove the grease filters.
• Mark a central line on the wall to
facilitate the installation procedure (1 1 1 1 1).
Position the drilling template so that
the median line printed on it
corresponds to the central line
marked previously, and so that the
lower side of the template
corresponds to the lower part of the
cooker hood once it has been fitted
(2
2
2 2
2).
• Rest support bracket on the drilling
template allowing it to coincide with
the traced rectangle, mark the two
outer drill holes and drill, remove the
drilling template, insert 2 wall screw
anchors and affix the cooker hood
support bracket using two 5x45 mm
(3)
(3) (3) (3) (3).
Attention!
Attention! Attention! Attention! Attention! 2 brackets are required to
fix to the wall with a total of 4 wall
screw anchors and 4 x 5x45 mm
screws.
• ••
•• Carry out 4 drill holes to permanently
fix the cooker hood (4) (4)
(4) (4)
(4).
• ••
•• Provide for the electrical outlet on the
wall in the area immediately above
the brackets (5)
(5)
(5) (5) (5).
• ••
•• Place the chimney support bracket
“L” “L”
“L” “L” “L” on the wall adherent to the
ceiling, use the support bracket as a
drilling template (the small slit
opening on the bracket must coinci-
de with the line previously marked on
the wall see operation 1
1
1 1 1) and mark 2
holes with a pencil, drill 2 (Ø8mm)
holes, insert the screw anchors and
fix the chimney support bracket to
the wall using two 5x45 mm screws
(6)
(6) (6) (6) (6).
• •• •• Insert the side panels from the top
into the appropriate track guides. The
acidified side should face inwards (7)
(7) (7) (7) (7).
• •• •• Hang the cooker hood on the bracket
(8) (8)
(8) (8)
(8).
• ••
•• Regulate the distance of the cooker
hood from the wall (9) (9)
(9) (9)
(9).
• ••
•• Regulate the cooker hood’s horizontal
axis (10) (10)
(10) (10)
(10).
• ••
•• Permanently fix the cooker hood to
the wall using four 5x45 mm screws
and washers (11
11
11 11 11 - ABSOLUTELY
NECESSARY).
• ••
•• Carry out the electrical connection
(12) (12) (12) (12) (12).