Electrolux EFA 90600, User Manual

Page: 5 / 192

5 ENGLISH
4.1 Grease fi lter - The grease fi lter must
be cleaned once a month using non
aggressive detergents, either by hand or
in the dishwasher, which must be set to a
low temperature and a short cycle. When
washed in a dishwasher, the grease
fi lter
may discolour slightly, but this does not
affect its
fi ltering capacity.
EFC 90600 EFA 90600
4.2 NON-washable activated charcoal
fi lter - The saturation of the charcoal fi lter
occurs after more or less prolonged use,
depending on the type of cooking and the
regularity of cleaning of the grease fi lter.
In any case it is necessary to replace the
cartridge at least every four mounths.
The charcoal fi lter may NOT be washed or
regenerated.
The hood is provided with a special power
cable ; if the cable is damaged, request
a new one from Technical Service. The
minimum distance between the supporting
surface for the cooking equipment on the
hob and the lowest part of the range hood
must be not less than 50cm from electric
cookers and 65cm from gas or mixed
cookers. If the instructions for installation
for the gas hob specify a greater distance,
this must be adhered to.
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat
fi lters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic
cleaning recommendations of the
cooker hood and replacement of the
filters may cause fire risks. Therefore,
we recommend observing these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fi re damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.