6.7.1. Input philosophy: alter program
l
Alter program during the prestart mode
The door is still open at that moment!
1.
Program has been selected but did not yet start
Ä
Corresponding program LED is lit.
Ä
Presumable run time is flashing in the display.
2.
By pressing the new desired program key shortly it is possible to alter directly.
Options already selected before are cleared and have to be selected anew.
Ä
New selected program LED is lit.
Ä
Presumable new run time is flashing in the display.
3.
Before the door has been closed it can be altered as many times as one wants.
Only when the door has been closed, the program will start automatically.
Special feature when a start time was selected before!
1.
Program and start time have been selected but did not yet start.
Ä
LEDs of program and "SZV" are lit.
Ä
Programmed start time is flashing in the display.
2.
By pressing the new desired program key shortly it is possible to alter directly.
The start-time preselection already selected is preserved after the alteration! Program
options already selected before, however, are deleted and must be selected anew.
Ä
New program LED and "SZV" LED are lit.
Ä
Run time to be expected is flashing in the display for 2 sec., afterwards the
start time is flashing again.
If the selected start time is already running down (the time is permanently lit in the
display) you have to press the new desired program key a longer time (about 6 seconds)
for alteration.
2.
1.
105
93
Display blinkt
S5
LD3
LD5
Display blinkt
3.
165
Display blinkt
S2
LD2
EDW 1503 / VGA
LD1
LD2
LD3
LD4
LD5
LD6
S1
S2
S3
S4
S5
S6
LD10
LD11
LD12
1
99
S0
26
