25
Technical data
Height x Width x Depth
85x60x60cm
Depth with the door open
117cm
Height adjustable from
1.0/–0.4cm
Empty weight
approx. 46 kg
Load (depending on the program)
max. 5kg
(Different loads in some countries
are due to different measuring methods)
Power consumption in acc. with IEC 1121 s.e.
3.5
kWh
(5 kg Cotton, spun at 800 revolutions per minute,
program COTTON CUPBOARD DRY - BAUMWOLLE
SCHRANKTROCKEN)
Area of use
Household
Permissible ambient tempe5°C up to +35°C
;
This appliance complies with the following
EC directives:
– 73/23/EEC of 19/2/1973 ’Low voltage
directive’
– 89/336/EEC of 3/5/1989 ’EMC directive’
including the
Modification directive 92/31/EEC
Installation and electrical connection
Please refer to the type plate for specifications about
the power supply. The nominal voltage stated on the
type plate and type of current must be identical with
the nominal voltage and type of current at the point of
installation. Also refer to the type plate for the fuse
required.
Information for the electrician
When connecting the appliance without a plug, care
must be taken that this is done correctly. Please fol-
low the relevant information in the section on install-
ing and connecting the appliance.
For appliances with variable voltage settings, the
switch-over diagram can be found on the cover of the
connection box at the back of the appliance.
If the appliance is connected by a plug to 230 V AC,
only a Type 12 L+N+PE 250 V, 10 A Swiss plug may
be used in accordance with Standard Specifications
Sheet SEV 6534-2,1991. The plug must be installed
in phase in accordance with the rating plate (it is
essential that phase L of the socket is contacted with
the brown wire of the mains cable).
Improper connection can lead to the risk of a fire in
the dryer.
Special accessories
You can obtain the following special accessories from
your retailer.
Drainage kit
With this kit (E-No. 916 019 000) you can lead the
condensate directly into a drain (sink, siphon, drain
grating) with a maximum feed height of 1m above the
floor on which the dryer is standing (3m Length).
Emptying he condensate container is then no longer
necessary.
You can then suppress the EMPTY WATER
(BEHÄLTER) indicator at the end of each program
with the aid of the appliance programming features
(see " Programming possibilities" section). However,
the condensate container must be inserted correctly
in the operator control mask.
