22
If you do not find the required information in this man-
ual to remedy a disturbance, please call the customer
service.
Replace the interior light
1.
A replacement bulb can be purchased through
your local Electrolux Service Force Centre (Part
No: 647072580).
1
Warning!
Never use standard light bulbs in
your dryer.
1.
Isolate the appliance from the mains supply.
2.
Screw-off the bulb cover. (The bulb is located at
the top behind the door; see
Front view
).
3.
Replace the defective bulb.
4.
Screw-on the bulb cover.
1
Warning!
For safety reasons the bulb cover
must be screwed-on. The dryer must not be
operated, without the cover in place.
The remaining running time display
changes rapidly.
The remaining running time is
adjusted automatically depending
on the type of items being washed,
the washing time and the degree of
dampness.
Automatic process. There is no unit
fault.
Display EMPTY WATER (BEHÄL-
TER) is lit
Condensate container full
Empty the condensate container
EMPTY WATER (BEHÄLTER) indi-
cator illuminated, even though the
container has already been emptied
Foreign bodies, e. g. animal hairs,
can block the inlet nozzle as well as
the valve on the end of the con-
tainer
With the container pulled out, switch
on the appliance momentarily. The
blockage can be removed from the
container shaft or the hair cleaned
out of the valve
The dryer terminates the drying
process automatically: END
(ENDE) is displayed shortly after
program start; no display of the
extent of drying
Too dry or too little laundry filled-in
for the selected program
Select time program or higher dry-
ing stage (e.g. EXTRA DRY
(EXTRATROCKEN) instead of
VERY DRY (STARKTROCKEN))
The drying process takes unusually
long. 4.5 hours after the beginning
of the drying process:
- END (ENDE) display is illuminated
- acoustic signal sounds
- discontinuation of the drying proc-
ess
-
program run display is flashing
- error code
C 6
is displayed
SPECIAL CARE (SCHON) button
pressed and too much laundry
filled-in
Check the program selection: SPE-
CIAL CARE (SCHON) button
appropriate only for laundry
amounts up to 2.5kg
Too much laundry
filled-in
Reduce the amount of laundry
filled-in
Laundry too damp
Pre-dry the laundry more thor-
oughly
Symptom
Possible cause
Solution
