Electrolux EBSL80ACN, User Manual, Page: 41 / 52

The pyrolytic cleaning
procedure cannot start:
• if you did not remove the core
temperature sensor plug from the
socket.
• if you did not fully close the oven door.
Remove the worst dirt manually.
CAUTION!
If there are other appliances
installed in the same cabinet,
do not use them at the same
time as the function:
Pyrolysis. It can cause
damage to the appliance.
1. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
2. Activate the appliance and select from
the main menu the function: Pyrolysis.
Press
to confirm.
3. Set the duration of the cleaning
procedure:
Option Description
Quick 1 h for a low
degree of dirt
Normal 1 h 30 min
for a usual
degree of dirt
Intense 2 h 30 min
for a high de-
gree of dirt
4. Touch to confirm.
When the pyrolytic cleaning
starts, the appliance door is
locked and the lamp does not
work.
To stop the pyrolytic cleaning
before it is completed,
deactivate the appliance.
WARNING!
After the function is
completed, the appliance is
very hot. Let it cool down.
There is a risk of burns.
After the function is
completed, the door stays
locked for the cool down
phase. Some of the appliance
functions are not available
during the cool down phase.
12.4 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different
models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5.
Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
ENGLISH 41