Electrolux EBGL70G, User Manual

Page: 22 / 28

Installing the shelf support rails
Install the shelf support rails in the opposite
sequence.
Oven lamp
Warning! There is a danger of
electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
Replacing the rear oven light bulb/cleaning
the glass cover
1. Turn the glass cover anti-clockwise to re-
move it.
2. Remove seals and metal ring, and clean
the glass cover.
3. Replace the oven light bulb with applica-
ble 300°C heat-resistant oven light bulb.
4. Fit seals and metal ring to the glass cover.
5. Install the glass cover.
Replacing the oven lamp (left side of
the appliance)
Cleaning the glass cover
1. Remove the left shelf support rail.
2. Use a cross-tip screwdriver to remove
the glass cover.
3. Take off the metal frame and seal and
clean.
4. If necessary: Replace the oven lamp.
Technical data: 25 Watt, 230 V, heat re-
sistant.
5. Install metal frame and seal and tighten
screws.
6. Install the left shelf support rail.
Oven door
To clean the oven door remove it.
Caution! Be careful when you remove
the door from the appliance. The door
is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
A
A
3. Close the oven door until the first posi-
tion (angle approximately 45°).
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
Hanging the oven door back on its hinges
1. Hold of the oven door with one hand on
each side and hold at an angle of ap-
proximately 45°.
22 electrolux