Component Teardown and Testing
4-8
Stirrer Motor Removal
1. Disconnect power and remove grille screws(2).
2. Remove grille and the bracket duct upper screw(1).
3. Remove the bracket duct upper and disconnect the
stirrer motor wire. (See Figure 4-17)
4. Remove stirrer motor screws(1) and lift up stirrer
motor after turning left.
Stirrer Removal
The stirrer is located on the upper side of the cavity. The
oven uses a top feed wave guide.
1. Disconnect power and open the door.
2. Remove the screws (3) and turn the stirrer cover left.
(See Figure 4-18)
3. Remove stirrer cover and the stirrer will come with it.
Stirrer Motor
Cover Stirrer
Screws
Figure 4-17. Stirrer Motor Removal
Figure 4-18. Stirrer Removal
Main Fuse Removal
The fuse is located on the upper duct mounted to the
Noise filter.
1. Disconnect power and remove grille.
2. Replace the fuse. (See Figure 4-15)
3. When the 20A fuse blows out by the operation of the
interlock monitor switch, replace the primary interlock
switch, door sensing switch, interlock monitor switch
and power relay.
4. When the above 3 switches operate properly, check
if any other part such as the control circuit board,
blower motor or high voltage transformer is defective.
Drive Motor Removal
1. Disconnect power.
2. Remove the three screws at the assy base bottom.
3. Remove the plastic cover (fixed with a screw) that
covers the motor.
4. Remove all of the wires connected.
5. Remove a screw from the motor. (See Figure 4-16)
6. Turn the motor to the right and remove it.
7. After replacing the motor, re-install it on the accurate
position of the coupler.
8. Assemble in the reverse order.
Main Fuse
Figure 4-15. Fuse Removal
Base Plate
Screw
Drive Motor
Figure 4-16. Drive Motor Removal
Summary of Contents for E30MH65GPSA
