Electrolux E30MC75P, Use And Care Manual

Page: 74 / 80

74
Before you call
Problem Solution
Soil not completely removed after
self-cleaning cycle is completed
• Failure to clean bottom, from top of oven, frame of
oven or door area outside oven seal. These areas
are not in the self-cleaning area, but get hot enough
to burn on residue. Clean these areas before the
self-cleaning cycle is started. Burned on residue
can be cleaned with a stiff nylon brush and water
or a nylon scrubber. Be careful not to damage oven
gasket.
• Excessive spillovers in oven. Set the self-clean cycle
for longer cleaning time.
Oven smokes excessively during
broiling
• Control not set properly. Follow broiling instructions
under
Setting Oven Controls
. Meat too close to the
broil element. Reposition the broil rack to provide
proper clearance between the meat & the element.
Preheat the broil element for searing. Meat not
properly prepared. Remove excess fat from meat.
Cut remaining fatty edges to prevent curling, but do
not cut into lean. Insert on broiler pan wrong side
up & grease not draining. Always place grid on the
broiler pan with ribs up & slots down to allow grease
to drip into pan (some models). Grease has built up
on oven surfaces. Regular cleaning is necessary
when broiling frequently. Old grease or food spatters
cause excessive smoking.
Oven control panel beeps &
displays any F code error (for
example F10, F11, F13, F14, F15,
F20, F23, F25, F30, F31 or F90)
• Oven control has detected a fault or error condition.
Press CANCEL to clear the display & stop beeping.
Try the bake or broil feature again. If the F code error
repeats, remove power supply to appliance, wait
5 minutes and then repower the appliance and set
clock for the time of day. Try the bake or broil feature
again. If the fault recurs, record fault, call for service.
Fan noise occurring after the oven
is turned off.
• Some models are equipped with a cooling fan that
runs during the cooking process to cool internal
electronic components. It is normal for this fan to
continue to run for an extended period of time, even
when the oven is off.
Oven racks do not slide easily.
•
This appliance comes with lubricated porcelain oven racks,
which can remain in the oven during the self-clean cycle.
Do not clean this vegetable oil lubrication off the racks. It
is important that the sides of the oven racks always have
a light coating of vegetable oil. To maintain optimal rack
performance, re-apply a thin layer of vegetable oil to the
sides of the rack after every self-clean cycle or when the
rack becomes difficult to slide.
Poor baking results
• Many factors affect baking results. Make sure the
proper oven rack position is used. Center food in the
oven and space pans to allow air to circulate. Allow
the oven to preheat to the set temperature before
placing food in the oven. Try adjusting the recipe’s
recommended temperature or baking time. If you
feel the oven is too hot or cool, see “Adjusting Oven
Temperature” in the Setting Your Preferences
section of this Use & Care Guide.
Solutions to Common Oven Problems
Questions or for service call: 1-877-4ELECTR OLUX (1-877-435-3287)