Electrolux E24ID74QPS, Technical & Service Manual

Page: 11 / 30

11
4.1 Error Management
In Durham range, the error codes are defined in
families of errors and current errors, displayed as:
iXY
i = error indication
X = family of the error
Y = current error
4.2 Display of Error Codes
The complete error code will be stored among the
three errors that can be stored by the appliance. A
new error code is only stored if it differs from the last
one stored. The three most recent error codes can be
displayed only in Service Mode or using the Sidekick
tool.
Only the error family codes are displayed to the user.
The complete error codes are displayed in Service
Mode.
Appliances with a display will show the complete
error codes as above format.
Appliances without a display (EDW4905 and
EDW5905) will show the error codes by a number of
flashes of 2 indicator LEDs (L4 and L5). The number to
flashing of the left-hand-side LED (L4) displays family
code and the right-hand-side LED (L5) displays the
current error. For example, error code i41 = L4 flashes
4 times… L5 flashes once… L4 flashes 4 times… L5
flashes once…
4.3 Error Code Description
“i00” code family: Low mains
voltage
The electronic board makes sure the dishwasher
operates within certain voltage limits. If during a
cycle the voltage drops below the lowest limit, the
electronic board suspends all loads and interrupts the
cycle under way. The “i00” alarm is then triggered.
• The lowest main voltage threshold is 180 Volt.
• If the voltage goes back to over 186 Volt, the
electronic board cancels the error status and the
cycle resumes. The “i00” alarm is also deleted.
• If the mains voltage continues to exceed the
maximum threshold, the electronic board does
not do anything.
IMPORTANT: the “i00” alarm is not stored and
cannot therefore be read in Service Mode.
“i10” Code - family: Water Tap
Closed
“i10” code: during static filling
This error code is used to display problems with the
water inlet tap being closed at the beginning of the
program. It is set up to detect problems during the
static water filling. A drain phase is performed before
the error is displayed to the user.
• Acoustic signal and visual error, depending on
the appliance customization; the program can be
restarted
• The water level defined is not reached within the
time limit set
• The time limit set starts when the fill Solenoid
Valve is opened
• The time limit set is reset when the fill Solenoid
Valve is closed
• The water will first be drained before an error is
displayed to the user
• Time limit set: Normal 90 sec; Test cycle = 30 sec
(times could differ as they are defined in the MCF).
“i11” code: during dynamic filling
• Acoustic signal and visual error, depending on
the appliance customization; the program can be
restarted
• The water level defined is not reached within the
time limit set
• The time limit set starts when the fill Solenoid
Valve is opened
• The time limit set is reset when the fill Solenoid
Valve is closed
• The water will first be drained before an error is
displayed to the user
• Time limit set: Normal 120 sec; Test cycle = 60
sec (times could differ as they are defined in the
washing cycle specifications).
4. Error Codes