DOC. NO. 5956.65J.00
P. 64 / 174
EFS - Dishwashing Systems Platform
Electrolux Professional
NHT - KHT - EHT
PROG 118
1.
Switch OFF and then switch ON the machine.
2.
Enter into CFG parameter family and set the following parameters:
Hood Type and undercounter.
Pressure boiler.
Manual Hood.
Default values for Hood Type models.
Disabled (for this appliance SOFT START is NOT possible)..
Tank heater works only if boiler temperature reached.
The tank is filled into the traditional way.
Detergent level switches not enabled.
ACTIVE function disabled.
Regeneration cycle disabled (only for dishwashers with non-continuous water softener).
Alarms enabled.
Boiler electronic level sensor.
Resin regeneration cycle forcing.
Rinse water max. hardness.
Boiler heating control.
3.
Switch OFF and then switch ON the machine.
4.
Modify Factory parameters:
Enter into FAC parameter family and set the following parameters.
Boiler Temperature Threshold.
Boiler temperature: alarm threshold.
Boiler Temperature Adjust.
Boiler standby function enabled.
Booster Function.
During stand-by boiler is kept at lower temperature than Temperature Threshold.
Tub Temperature: Threshold.
Tank temperature: alarm threshold.
5.
Modify the cycle parameters:
Cycle 1 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Cycle 2 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Cycle 3 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Boiler Temperature Threshold for Cycle 3.
