6
www.electrolux.com
CNT
CNS
KR
ID
TH
VN
EN
•
Do not let the power cord come into contact with hot surfaces or hang over the edge of a table or
counter.
•
The kettle can only be used with the base unit provided.
•
This appliance is not intended to be operated by means of an external timer or separate remote
control system.
•
This appliance is for indoor use only.
•
This appliance is intended for domestic use only. Electrolux will not accept any liability for possible
damage caused by improper or incorrect use.
•
This appliance is suitable to operate on both 50 and 60Hz.
•
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or connected
to a circuit that is regularly switched on and off by the utility.
GETTING STARTED
1. Before first use, wipe the inside and outside of the kettle with a damp cloth.
2. Place the base unit on a firm and flat surface. Plug the mains plug into a wall socket. Redundant cord
can be wound into the bottom of base unit.
3. Press the button to open the lid, pour water into the kettle. Make sure water level is visible in the water
level indicator, but not exceeding the Max. mark. (Min. 0.75L - Max. 1.7L).
4. Close the lid and make sure it snaps in correctly. Otherwise the auto switch off function will not
work reliably. Place the kettle onto the base. Press down the ON/OFF switch; the indicator light will
illuminate and the kettle will start to heat up.
5. The automatic switch off function. When the water has boiled or the kettle is moved from the base, it
will switch off automatically. If you wish to stop the heating process before the water is boiling, simply
lift up the ON/OFF switch to the OFF position.
CLEANING AND CARE
1.
Before cleaning, always unplug the appliance. Never rinse or immerse the kettle or base unit in water.
Just wipe with a damp cloth, using no abrasive detergents. Occasionally rinse out the kettle with clean
water.
2. To clean the mesh filter, grab the strainer insert and lift out. Cleaning the heating plate – superficial
spots of rust may appear on the base unit. Remove with a stainless steel cleaning agent.
3. Decalcifying is recommended regularly, depending on water hardness. Fill the kettle with water and
decalcifier according to decalcifier product instructions. Do not boil the solution as it may foam over.
Afterwards, rinse kettle thoroughly with fresh water.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
The appliance switches off before
boiling.
Too much lime scale at the base
of the kettle.
Run the decalcifying procedure.
The appliance does not switch off.
Close the lid until it locks.
Insert the strainer correctly.
The appliance cannot be
switched on.
After operating with little or no
water, the appliance has not
cooled down sufficiently.
Allow to cool a short time and try
again.
