Electrolux COE7P31X, User Manual, Page: 36 / 44

2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Turn on the oven.
4. Press again and again until the
display shows "Pyro" and the number
of the cleaning programme.
5. Press .
6. Press or to set the duration of
the cleaning procedure:
Option Description
1 1 h for a low
degree of dirt
2 1 h 30 min
for a usual
degree of dirt
3 3 h for a high
degree of dirt
You can use the End function to
delay the start of the cleaning
procedure.
7. Press to confirm.
12.4 Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol flashes in the display after
each deactivation of the appliance for the
next 10 seconds.
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
12.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
1
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
www.electrolux.com 36