45
S
9S
2
1
6
6
4
7
5
8
12
13
13
14
15
15
4
4
11
9S
9S
9K
9K
9K
9K
4
Ø 120mm
10S
14
7
K
9K
9K
6
6
7
7
3
3
Wall unit mounting - Fig. 6
•
Put the template onto the wall
(1)
and drill two Ø12mm holes
(2)
.
•
Fit two hooks
(3)
on the drilled holes.
•
Remove the metal filters
(4)
and hang the hood on the hooks and adjust the position of the hood using the two
screws on the bottom of the hooks
(5)
.
•
Depending on the model, mark 2 or 4 points
(6)
. Remove the hood and drill 2 or 4 Ø8mm holes on the marked
points. Fit 2 or 4 Ø8mm wall dowels, Hang again the hood and fix the hood permanently with 2 or 4 screws
5X45
(7)
.
•
Fix the chimney support
(8)
with two screws 5 x 45 mm and two wall dowels on the wall close to the ceiling.
•
For the extraction version:
Fit the connection ring
(S)
on the top of the hood with two screws Ø 3,5 x 6,5
mm
(9S)
then fit a vent hose long enough to reach the outside
(10S).
For the recirculation version:
Fix definitively the deflector
(K)
on the top of the hood with two screws Ø
3,5 x 6,5 mm
(9K)
.
•
Prepare the electric connection
(11)
(see relative chapter).
•
Fit the chimney
(12)
and fix it on the chimney support with two screws 3 x 9 mm
(13)
.
The lower part of the chimney must be slid down and inserted on the housing on the upper part of the hood
(14)
.
•
Fit the two grids
(15)
on both sides
of the chimney.
Fig. 6
