Page 44
Replacing Drawer Glide Rails
Once the mounting screw is removed extend the outer track of the glide rail until it stops. Pull forward
firmly until the hooks on the back of the rail disengage from the slots in the oven cavity side wall.
( Fig. 10 & 11 )
The lower oven drawer glide rails (Fig. 8) clip into
the side wall of the lower oven cavity and are se-
cured by one screw in each rail.
The mounting screw is accessed through a hole in
the glide rail outer track. (Fig. 9) .
Remove
Screw
Fig. 8
Fig. 9
Pull Forward
Glide Rail Hooks
Slots
Fig. 11
Fig. 10
Replacing Drawer seal
The rubber drawer seal is secured to the drawer liner by metal
spring clips that are integral to the seal. To remove the seal grasp
securely at the clip and pull away from the liner. Replace by
positioning the point of the clip into the hole and pressing in until
the clip locks into place.
Spring Clip
Summary of Contents for CEI30GF5G Series
