Page 20
LUxURy™ Lighting
When the oven door is opened or the LIGHT keypad
on the touch control panel is pressed the interior
oven halogen lights (photo B) come on and brighten
gradually. When turned off they dim gradually
until they are completely off. This feature is also
sometimes referred to as “Ramp Up lighting”.
Photo B
The incremental changing of the oven lights is
controlled by the VSC board. A triac on the board
gradually increases the voltage to the lights over a
2 - 3 second time span until the lights are on at full
power.
If none of the halogen oven lights operate, plug
in the range and open the oven door. Test for
approximately 120 volts AC at pins 1 & 3 of the P2
wire harness connector (brown & white wires) on the
VSC board (photo C).
Always use special care when making live voltage
tests.
If the voltage is correct then the failure is caused by
defective bulbs, sockets or wiring connections.
If the voltage is incorrect the problem could be
caused by a defective door switch, VSC board, or
EOC.
Test the contacts of the oven door switch by
disconnecting the P10 connector on the EOC and
checking for continuity between the grey and pink
wires in the wire harness.
P6
P2
Photo C
Pin 3
Pin 1
P1
Summary of Contents for CEI30GF5G Series
