9
PREPARATION FOR USE
After filling the batteries must stand for at least 1
hour and then they must be filled up if necessary.
After one further hour the batteries must be
recharged: remove the battery caps during the
recharge operation.
The new batteries will gradually “run in “ and will
increase their capacity.
The maximum capacity will be achieved in about
10 charge/discharge cycles.
When necessary the batteries must be charged
using an appropriate battery charger. Remove the
battery caps during the charging operation.
Check that the Volt and Hertz
reading of the mains supply
correspond to those of the battery
charger.
For further information about battery
maintenance see also the relevant
paragraph.
16
Also the tilting of the squeegee can be adjusted
by means of the dedicated knob, in order to
improve the drying capability of the machine.
Move the machine slowly forward, and adjust the
squeegee pressure and tilting controls until the lips
bend over evenly as illustrated below.
The lips must be replaced when they become
feather edged or torn.
When the recovery tank (dirty water) will be filled
the red light
A
will turn “on”; within 5 seconds the
automatic switch-off of the suction motor will also
occur.
In order to be able to re-use the machine the
recovery tank must be emptied. Then lift the
squeegee and the brushes by means of the
relevant lever and pedal. Turn the master key OFF
and disconnect the hose.
SCRUBBING AND DRYING OPERATION
TRAVEL DIRECTION
FLOOR LEVEL
A
water
level sensor